132 



b. Lv^gs will be placed on haad-rig and savm into lumJaer of 

 varying sizes, slabs and side cute will be chipped and stored for 

 delivery to TP. Sawdust will be collected for shipment to TP. 



c. Lumber will be edged and trimmed in the mill. Residue 

 will be chipped and collected for delivery to TP, 



d. Lumber will be sorted and stacked prior to placing into 

 dry kilns. Lumber will be dried at temperatures of 180 degrees F 

 for A minimum of 12 hours, reducing the moisture content to 

 approxijfnately 12-14%. All material used in stacking the lumber for 

 the drying process will be subjected to the same temperatures as 

 the treated lumber. 



e. All sawdust, wood chips and other by-products generated 

 by sawing or processing the lo-^s (lumber) will be processed into 

 particle board products at the Timber Products Company plant in 

 Medford, Oregon. This material will be transported between BCC and 

 TP in chip vans with the screens and top covered to prevent sawdust 

 or chips from escaping. After unloading, the trailer will be swept 

 free of all chips and sawdust, including exterior surfaces such as 

 bumpers and gate. Processing of the sawdust and chips will occur 

 within 10 days of delivery to TP. The route of tra\/el from the BCC 

 Whit© City plant will be south on highway 62 to Medford, Oregon, 

 then along local streets to the TP Plant at 25 East McAndrews Road, 

 Medford, Oregon, 97501, 



6. The logs which are processed into veneer at the BCC White City 

 Veneer Mill will be processed as follows: 



a Logs will be cut into peeler lengths at the block saws. 

 Sawdusu will be collected for processing by TP. 



b. Peeler blocks will be moved into the steam vats for heat 

 treatment prior to peeling. Blocks will be steamed for 

 approximately 8 to 12 hours at 130 degrees F. 



G. Blocks will be peeled down to a 4 inch core. 

 Temperatures of the core will be measured to verify that they have 

 been heated to approximately 110 degrees F. 



d. Veneer meeting usable qpjality atandeirds will be 

 transported to the BCC Rogue Valley Plywood mill where it will be 

 dried at ten^eratures of 3 60 degrees F, for approximately 10 to 20 

 minutes. Dried veneer will then be processed into plywood. 



e. Veneer not meeting usable quality standards will be 

 chapped and sent to TP for processing. 



f . Cores will be chipped and sent to TP for processing. 



COMPLIANCE AGREEMENT 



