SELLING LUMBER 435 



The Standard Widths of S. 4 S. shall be as follows: 

 1x4 shall be 3% inches. 

 1x5 shall be 4% inches. 

 1x6 shall be 5% inches. 

 1x7 shall be 6 l /2 inches. 

 1x8 shall be 7y 2 inches. 

 1x9 shall be 8% inches. 

 1x10 shall be 9 l / 2 inches. 

 1x11 shall be 10% inches. 

 1x12 shall be 11% inches. 



The foregoing widths shall also apply to stock thicker than 

 1-inch. 



107. Moulded Casing and Base shall be worked to %-inch, 

 as per patterns shown in Southern Pine Association Moulding 

 Book, 1916 Edition. 



108. Flooring. The standard of 1x3, 1x4 and 1x6 inches 

 "D and Better" shall be worked to 13/16x2%, 2%, 3% and 5% 

 inches; 1 54-inch Flooring shall be worked to 1-1/16 inches thick, 

 1%-inch Flooring shall be worked to 1-5/16 inches thick, the 

 same width and matching as 1-inch stock. 



109. Drop Siding. D. & M. shall be worked to 24x3% 

 and 5%-inch face, 3% and 5% over all. Worked Shiplap %x3- 

 inch face, 3% over all ; %x5-inch face, 5% over all. 



Patterns that are not shown in Southern Pine Association 

 Moulding Book of 1916 Edition are considered special. 



110. Ceiling shall be worked to the following: 

 ^-inch Ceiling, 5/16-inch. 



%-inch Ceiling, 7/16-inch. 



5^-inch Ceiling, 9/16-inch. 



24-inch Ceiling, 11/16-inch. 



Same width as Flooring. 



The standard working of Ceiling shall be beaded center 

 and edge with slight bevel on groove edge. 



The bead on all Ceiling and Partition shall be depressed 

 1/32 of an inch below surface line of piece. 



111. Partition shall be worked to the following: 24x3% 

 and 5% inches, with same standard for location and size of 

 bead as applies to Ceiling. (See Sec. 110.) 



112. Bevel Siding to be made from stock S. 4 S. worked 

 to 13/16x3% and 5% and resawed on a bevel. 



