116 W. & L. E. GURLEY, TROY, NEW YORK 



the slot ( 12 I in the most convenient position. Cut the adhe-i\r 

 |u|..T nn the margin of the record sheet. With finger on the 

 inside of the cylinder (8), push out the ends of the record sheet, 

 which <\m readiK he taken off from the outside of tin- > limln. 

 Insert the corner >l the new sheet marked 1.00; graduall\ 

 press it into the slot until the upper end of the sheet is in the 

 slot; hrinj: the paper around the cylinder and insert the corner 

 of the sheet marked 0, pressing it in without kinking the paper 

 until the end is in slot (12). (See Fig. 51, page 109). Stick 

 a small piece of adhesive paper on the margin and over the 

 slot. When folding the edge of the record sheets, be careful to 

 keep the folded edge straight, or trouble will be experienced in 

 inserting the record sheet in the slot in the cylinder. 



Care of the record sheets. It will facilitate putting re. md 

 sheets on the cylinder if after folding the edges, about twelve 

 record sheets are put in a 2-inch paper tube with rulings toward 

 the outside. Roll and put one sheet in at a lime, so when one 

 is to be put on the register, it will not be necessary to take all 

 of the sheets out of the tube. Keep the sheets in a dry place, 

 so that the paper will be hard while inserting the record sheet 

 in the cylinder. If it is desirable to keep the record sheets in 

 the gage house, the paper tube with the record sheets should 

 be kept in a two-quart fruit jar, and when taking record six < -I- 

 out, open and close the jar as quicklv as possible. If the 

 atmosphere is damp when filling the jar with record sheets, 

 place the jar with the sheets in a hot place and when heated 

 thoroughly, put a rubber ring on the jar and screw on the cover. 



To oil the register. The clock will run two years with one 

 oiling; however, if it stands idle for one month, it will be 

 necessary to take off the hands and face and oil it with the l<-t 

 clock oil. The bearings of the screws and of the cylinder 

 should be oiled with the above mentioned oil about four times 

 a year. A very small amount of oil should be used on the 

 screws every month. A fine wire should be used in applying 

 the oil. 



