The ridge of the roof should be finished with 

 1" x 6" excepting in cases where galvanized iron roofing 

 is used, frith it, use galvanized ridge capping. 



SIDING. 



Use 1" x 12" boards and 1" x 3" battens, free 

 from loose knots and all knots of a greater diameter than 

 l^" . Boards should also be free from weather check, rot, 

 disfigurements and large pitch pockets. 



Finish the corners with 1" x 4" boards. 



FLOOR. 



Mo floor is provided for stall section, flooring 

 of the second story shall be of 1" x 12" board free from 

 loose knots with 1" x 3" battens under cracks- Strips 

 1" thick and 2" wide shall be placed on the floor joists 

 between the battens . 



STALLS. PARTITIONS. ETC. 



Place all stalls, feed boxes, partitions, etc. 

 as shown on the drawing . 



Racks for holding hay may be used if desired. 

 Where loose hay is to be fed, racks are especially 

 advantageous . 



If a grain box is needed, follow the plan shown 

 in Detail Wo. 6-E. Place it on second floor and provide 

 feed chutes to feed boxes. 



TOOL ROOM. 



A tool room as shown in the plan may or may not 

 be provided, at the discretion of the builder, Since a 

 barn of the mansard type of roof will be used almost 

 entirely for the storage of loose hay, it is probable that 

 all available r-pace will be needed for hay storage. 

 Ordinarily, therefore, the tool room will be omitted with 

 the mansard type of roof. 



-10- 



