of shingles over the bargtj board trim. Table Wo. B.M.-2 

 giveB data on shakes. If shakes are used, allow !" 

 projection at eaves and 1" projection over barge board 

 trim. 



The ridge of the roof should be finished with 

 1" x 6", excepting in cases v/here galvanized iron roof- 

 ing is used. With it, use galvanized idge capping. 



SIDING. 



Use 1" x 12" boards and 1" x 3" battens, free from 

 loose knots and all knots of a greater diameter than 

 li- inch. Boards should also be free from weather check, 

 rot, disfigurements and large pitch pockets. Finish the 

 corners with 1" x 4" boards. 



FLOOR . 



Except in the grain room or saddle room, at the 

 option of the builder flooring may or may not be used, 

 Ordinarily, if drainage is f-Tood, to not install the floor 

 will be advisable. If not installed, the items of floor- 

 ing after which the (<] marie appears, should be omitted 

 from the order list. If the floor is installed, it shall 

 be laid as shown in the plan. Note that the floor in the 

 stalls shall have a slope ore about 2" from front to back. 

 The flooring in the grain room shall be 1" x 12" boards, 

 double. The flooring overhead shall be 1" x 12" v;ith 

 5/8" x 3" battens under cracks, No floors shall be 

 placed in the shed. 



STALLS. PARTITIONS. 



The grain room partitions shall be put up as 

 shown in the plan,, and c.c.y te lined v/itb "beards or.d bttte 

 CF.re' shculc. be tthen to put on the lirdr:?- tight enough to 

 prevent the entrance of rodents . 



A detailed plan is given of the grain box in 

 Detail 6-B. If desired, it may te placed on a support to 

 provide more room under the mouth of the opening at the 

 bottom. 



-13- 



