The ridge of the roof should be finished \vith 

 1" x 6" excepting in cases where galvanized iron roofing 

 is used. With it, use galvanized ridge capping. 



SIDING. 



Use 1" x 12" boards and 1" x 3" battens, free 

 from loose knots and. all knots of a greater diameter than 

 !" Boards should also be free from weather check, rot, 

 disfigurements and large pitch pockets. Finish the 

 corners with 1" x 4" boards. 



FLOORS . 



Flooring in the stall section may or may not be 

 used, at the option of the builder. Ordinarily, if 

 drainage is good, it will be aavi sable not to install 

 the floor. If not installed, items of flooring after 

 which (tf) mark appears should be omitted from the order 

 list. If flooring is used, lay it parallel to the drive- 

 way behind the stalls, and at right angles to it within 

 the stalls --See Plan. Note the furring strip under stall 

 floor to give proper drainage to the stall floors. 



The floor of the grain room shall be double . 

 The upper flooring shall be of 1" x 12" lumber with 5/8 

 x 3" battens under craclrs . 



STALLS. PARTITIONS. ETC. 



Partitions on either side of v/agon space should 

 be finished in 1" x 12" beards; the doors are made of 

 the same material. 



The grain room may be lined with boards and 

 battens. Care should be taken to put on the lining 

 tight enough to prevent the entrance of rodents. 



A detailed plan is given of the grain box 

 in Detail Ho. 6-D. If desired, it mey be placed on a 

 support to provide more room under the mouth of the open- 

 ing at the bottom. 



