Place siding listed as follows: 



(r.) Rough lumber 1" x 12" and 1" x 3" battens placed 

 vertically. Mnterial should be free of loose knots and all 

 knots of G diameter greater than 1-|- inches and free from 

 weather chock, rot disfigurements and large pitch pockets 

 that naturally affect the soundness of the stick. Nail the, 

 board securely to the sills, girts, plates and studs with 3 - 

 lOd. nails at each member named. fasten battens with 6d. 

 wire nails placing 2 at each end and 1 on each side of the 

 battens approximately 18 inches apart throughout the length 

 of the batten. Clinch on the inside all projecting nails. 

 This style of siding shall be placed as shown on the plan. 



(b) 1" x 8" siding of same specifications as (a) laid 

 horizontally with a lap of 8 inches. Set the first board 

 at the bottom on a 1" x 2" strip nailed to studs. Exercise 

 care in spacing the siding in order that the lap will be 

 equal on each board. Nail siding at top and bottom at each 

 stud with a lOd. wire nail. 



(c) Rustic, drop or bevel siding of "C" Grade California 

 or No. 3 Grade Oregon. Nail siding with 2 - 8d. wire nails 

 at each stud. 



fd) Star A Star red cedar shingles placed 5 inches to 

 weather on 1" x 4" sheeting on 8 inch centers. Nail shingles 

 with 3d. fine galvanised nails. 



Style B. - C - D siding shall be placed as shown on 

 Plans 1-A and 1-B. 



In placing sheeting for shingle walls cut back the 

 sheeting the width of the door and window casing. Before 

 placing sheeting study the Detail 6-D showing door and window 

 frames where shingles are used. 



Floor extends only under the cooler and over the 

 open porch. 



-13- 



