SEED INSPECTION 



The number preceding each analysis is for identification and reference. The 

 line to the right of the letter "L" gives information copied from the label; that 

 to the right of "F" what was found in the laboratory analysis. 



All lots of seed included in this report were tested according to the Rules for 

 Seed Testing adopted by the Association of Official Seed Analysts. 



"Tolerance" is applied to both purity and germination, except for vegetable 

 seed found below the minimum germination standards adopted, in which instance 

 no tolerance is allowed. "Germination Tolerance" has been applied between 

 a given germination and the result of the germination test as follows: 



GIVEN GERMINATION PERCENT TOLERANCE PERCENT 



96 or over 5 



90 or over, but less than 96 6 



80 or over, but less than 90 7 



70 or over, but less than 80 8 



60 or over, but less than 70 9 



Less than 60 10 



In the determination of the tolerance for the percentage of the distinguishable 

 kind, type, or variety (pure seed), weed seeds, other crops seeds, and inert matter, 

 the sample shall be first considered as made up of two parts: (a) The percentage 

 of the component (pure seed, weed seed, crop seed or inert matter as the case 

 may be) being considered, and (b) the difference between that percentage and 

 100. The number represented by (a) is then multiplied by the number rep- 

 resented by (b) and the product is divided by 100. The resulting number is then 

 multiplied by 0.2 (2/10) and the resulting product added to 0.2 or 0.6 as indicated 

 in the following formulae: 



I a X b 

 Pure seed tolerance = 0.6 + I 0.2 X 



100 



Weed seeds, other crop seeds, and f ^ , 



inert matter tolerance = 0.2 4- { 0.2 X 



\ 100 



For Poa spp., Agrostis spp., Festuca spp., bromegrass, crested wheatgrass, 

 orchard grass, velvet grass, tall oatgrass, meadow foxtail, sweet vernalgrass, 

 Rhodes grass, Dallis grass, carpet grass, and Bermuda grass, and mixtures con- 

 taining these seeds singly or combined in excess of 50 percent, an additional 

 tolerance shall be allowed. This is to be obtained by adding to the regular 

 tolerance mentioned above the product obtained by multiph'ing the regular 

 tolerance by the lesser of "a" and"b" divided by 100. 



