CHAPTER VIII 

 SUPPLEMENTARY PROJECTS 



62. Sheep Rack and Feed Bunk (Fig. 118) . 



Directions: 



1) Frame up each end with 1" x 10" boards 3' 0" long, 

 cleated together on the outside by the two 1" x 4" strips, and 

 on the inside by the 1" x 3" strip upon which the trough floor 

 is to rest. Flush with the upper edge of this cleat, and with 

 each of the outside edges of the bunk end, fasten the 2" x 4" 

 corner posts or legs. 



r* /H-4 



FIG. 118. Sheep rack and feed bunk. 



2) Fasten the two bunk ends together by nailing in place 

 the top and bottom bunk rails. 



3) Lay the floor, nailing boards to the floor cleats on the 

 bunk ends and to the top of the legs. Fit the middle "V" 

 feed guides and the outside trough edge boards, nailing ends 

 of the same from outside of bunk end. 



4) From lower edges of feed guides to upper corners of ends 

 of bunk, draw lines to locate guide boards for the 1" x 12" 

 board and rack which hold feed. Construct and nail these 

 guides in place. 



79 



