80 



WOODWORKING 



5) Cut slats for rack and fasten together at top ends by 

 means of a 1" x 3" board, to which all are squarely nailed. 



6) Nail 1" x 12" feed boards in position to the inside guide 

 boards (A) . 



7) Place feed rack in position, supported by outside guide 

 boards (B) . Toe-nail the bottom of each rack slat to the "V" 



I pj Joint At A" 



JT 



^ 1_| Joint a^t B 



FIG. 119. Woodworking bench. 



feed guide board, and nail the top of the rack securely to the 

 V x 12" feed board, over the lower edge of which they should 

 lap by 3". This should be done after the V x 6" slide has 

 been placed in position. This should slide in the openings be- 

 tween the feed rack and the inside end guide boards with diffi- 

 culty, that it may be held in any particular position by fric- 

 tion, or it should be fastened thru grooves in the end boards of 

 rack by means of wing nut bolts. 



63. Directions for Woodworking Bench (Fig. 119). 

 1) Construct the frame by planing for each end : 



2 oak boards (uprights), each 1-3/4" x 4" x 2' 6". 



1 oak board (lower crosspiece), 1-3/4" x 3" x 2' 5". 



1 pine board (upper crosspiece), 1" x 11" x 2' 4". 



