88 



WOODWORKING 



3) Turn box bottom side up. Lay and nail floor boards to 

 end boards, and nail on 2" x 4" crosspieces. 



4) While box is bottom side up, place leg frames in position 

 and bore holes thru legs and side rails of box. Insert and 

 fasten bolts. Fit and nail the four length braces in position, 

 carefully locating center position for them on the crosspieces. 

 The lower ends of these braces butt against the 6", 2" x 4" 

 blocks already nailed to the lower leg frame crosspieces. 



5) Place bunk in upright position and insert and tighten 

 end rods. 



71. Saw Buck (Fig. 127). 



1) Saw legs of frame to lengths from 3" x 4" stock. 



FIG. 127. Saw buck. 



2) Locate, lay out and cut half -lap joints for each end of 

 frame. 



3) Lay out and cut 2" notches for thickness and width of 

 connecting braces. 



4) Bore holes for center rod in each half -lap joint connect- 

 ing ends of frame. Do this when each end of frame is halved 

 together. 



5) Plane and fit all brace rods. 



6) Form center rod, using draw-knife and spoke-shave on 



