Louden Spring Balance 

 Manger Divisions — Cont'd 



Plate 14 



We make three different 

 sizes of Manger Divisions, 

 as shown in Plate 14, which 

 also shows the divisions 

 fitted in the different sizes 

 of our Standardized Con- 

 crete Mangers for which 

 they are intended. 



The new No. 2 division 

 is for Fig. 1001 manger only. 

 It is not fitted with springs 

 or brace rod, and each 

 division is raised and low- 

 ered separately. It is inexpensive, and is designed for barns where it is not desired to put in the 

 expensive divisions. All other manger divisions are fitted with springs and brace rod. 



No. 3 division is intended for Figs. 1001 and 1002 mangers, and No. 4 for Figs. 1002 and 1003. 

 description of these mangers on pages 98 and 99. 



more 

 See 



Louden Spring Balance Mangers 



This illustration shows two sections of the Louden Spring Balance Galvanized Mangers in the 

 dairy barn on the farm of the University of Minnesota, at St. Paul. See how perfectly they line up and 

 how much higher they raise than the mangers shown in the rear which are not the Louden. The superior- 

 ity of the Louden Equipment speaks for itself. Louden Mangers are made regularly in sections of four. 



This was a somewhat difficult job to install on account of the large posts which are in the manger. We 

 found a way to get around the posts, as will be seen in the cut, without cutting the sections into single 

 mangers as was done with the mangers in the rear, which is objectionable and should be avoided if pos- 

 sible. It is better to have the large posts or columns in line with the stall posts and then the mangers 

 will not have to be cut to get around them. 



Page One hundred four 



