168 AMATEUR RODMAKING 



and while the glue is hot, empty the tube and 

 rinse well in hot water till perfectly clean of 

 glue, dry, and hang bottom up for further use. 



11 Too much care cannot be taken to prevent 

 rusting this tube as rust and dirt will spoil 

 glue and so much depends on the gluing. 



" I need not tell how to use this glue-pot, as 

 you have already given directions to have the 

 pieces for each joint wound spirally with 

 coarse thread. It will be well to unwind a 

 few inches at a time, commencing at the small 

 end. As the piece is unwound, and pushed 

 down in the glue, it will act like an egg-beater, 

 and consequently glue all surfaces. When half 

 of a piece has been thus unwound and whipped 

 in the glue, wind the thread back, pressing the 

 strips together and the glue out; then unwind 

 the other end to a little beyond where the glue 

 reached before, thus surely gluing every part; 

 then rewind and have a rag handy in a dish 

 of hot water to gently wipe most of the glue 

 from the outside of the joint. Do not wipe 

 too clean, for if a little glue is left on the 

 thread, all the better, and no trouble will be 

 found in taking off the winding." 



I have found that a piece of one-inch -gal- 

 vanized iron pipe makes an excellent glue-tank. 

 The plumber will supply it. Have him put a 



