THRESHING WITH SPECIALLY EQUIPPED SEPARATOR 205 



obstructed. The fan-blinds may be regulated so as to 

 blow out all of the "pops" if desired. When a heavy blast 

 is needed, care must be taken so that no good peanuts will 

 be blown over. This may be avoided by raising the rear of 

 the conveyor extension-sieve and the sheet iron extension 

 just back of the tailings auger. The bagger is of the 

 vibrating type, elevating the peanuts by pitching them from 

 notch to notch, thus avoiding breakage in elevating. The 

 fifteen-sixty-fourths-inch round hole screen in the bottom 

 of the elevator should be looked at from time to time to 

 see that it is clean. Do not allow the sand or dirt under 

 this screen to become so high as to interfere with the 

 operation of the bagger. The best results are obtained by 

 running it with a crossed belt. The special equipment for 

 peanut separators is furnished only for the eighteen by 

 thirty-sixth-inch size. 



FOR SPANISH PEANUT SEPARATORS: 



Pulleys on cylinder shaft for threshing Spanish Peanuts are the 

 same as those listed under Peas and Beans, 12-bar, page 194. 



FOR VIRGINIA PEANUT SEPARATORS (BELT): 



5063T Main Cylinder Pulley, 18" dia., runs cylinder 293 r. p. m. 



when 36" engine fly-wheel makes 146 r. p. m. 

 5789T Cylinder Pulley drives beater and crank, 22" dia. (remove 



tightener), runs crank normal speed, 230 r. p. m., with 



cylinder speed of 293 r. p. m. 

 A5065T Cylinder Pulley drives wind stacker, 20" dia., and A303H 



or B303H Wind Stacker Pulley, 8%" dia., run jack-shaft 



690 r. p. m. with cylinder speed of 293 r. p. m. 



FOR VIRGINIA PEANUT SEPARATORS (GEARED) : 



5071T Bevel Gear (47 teeth) and A5072T Cylinder Pinion (Steel) 

 or 5072T (Wood) (25 teeth) run cylinder about 308 r. p. 

 m. with spur pinion A8W (22 teeth) on horse power, 

 when the horses make 2>4 r. p. m. Pulleys, except 5063T, 

 same as for Virginia Peanut Belt Separators. 



