INSTRUCTIONS FOR 

 FOLDING BOAT WITH TRAILER 



NOTE: Read complete instructions thoroughly before proceeding. 



1. INITIAL STEPS 



1.1 The davit with winch and the stiff leg support are secured on 

 the trailer with two shock cords. Remove these cords. 



1.2 Carry the davit and stiff leg to the rear of the boat. Mount the 

 davit into one of the aft boom guides. Attach the stiff leg 

 between the davit and the clevis provided on the opposite boom 

 guide. Figure C-1. 



1.3 Remove and set aside temporarily the two turn buckle tie down 

 assemblies. Figure C-2 . 



1.4 Remove the locking angle sections that secure the engine boxes 

 using a 9/15 wrench. Do not discard the angle sections and 

 fasteners. Figure C-3. 



1.5 Using manpower, lift off the engine with box and place on the 

 ground in an upright position with the top hatch up. Figure C-4. 



NOTE: If the box seems to have an interference fit when you 

 remove same, use one of the turn buckle assemblies to 

 tighten up on the opposite end tilting the boat to clear 

 hasp and lock assembly. 



1.6 Repeat procedure for the remaining box. 



1.7 Replace the turn buckle tie down assemblies on both sides 

 temporarily and tighten lightly. Caution: The box with engine 

 is top heavy in upright position. 



2. EXTENDING THE WING HULLS 



2.1 Place the sling, color coded on one end in red, through the 

 center of the color coded (red) galvanized cleat on the folding 

 hull and loop it around itself. Figure C-5 . 



2.2 Place the boat snap end on the eye provided on the outside of 

 the hull, Figure C-6 . 



2.3 Attach the winch cable to the ring and winch the hull up 



the hull support as far as possible, then push it over center 

 beyond the teetering position. Figures C-7 to C-9. 



96 



