12. FOLDING THE HULLS 



12.1 When the trailer is up on shore, mount the two aft turn buckle 

 tie downs and install the davit and stiff leg support. 



12.2 Disconnect all engine controls. Remove fuel tanks from the outer 

 hulls. Remove the rails, outer and inner. Collapse the console 

 into the hull. Snap on the locks on the hatches. Lastly, 

 remove the engines. 



12.3 Before folding the hulls, you must position the hull supports 

 in their proper locations. 



NOTE : There are two supports for the outer hulls . The rear 

 support is placed just forward of the rear hatch main 

 deck section and the forward deck support is placed 

 approximately one foot aft of the bow roller. 



12.4 Attach the sling, remove the nuts, bolts and washers that 

 secure the two outer hulls and start folding the hulls. 



13. READYING TRAILER FOR TOWING 



13.1 The ball diameter for the coupler is 2 5/16". Secure and lock 

 the coupler. 



13.2 Attach the safety lines. 



13.3 Install the electrical hookup between the vehicle and the 

 trailer. 



14. MAINTENANCE 



14.1 Maintenance on the trailer should be minimal if after launching 

 the boat and again after retrieving it from the water, it is 

 washed down with fresh water. 



14.2 Periodically the bearings should be checked to insure that they 

 have the proper amount of grease. 



14.3 Tires should be checked periodically for proper pressure. 



100 



