34. Put the circular spline washer 

 into the outer housing. 



35. Put outer and inner housings together and solder the wires from the coil 

 on the inner housing with the wires sticking out of the outer housing. 

 Secure and insulate the soldered joints with heat-shrinkable tubing. Make 

 sure that the wires are long enough to repeat this procedure in case the 

 replacement of motor parts is necessary (see step 27). 



36. Bend the soldered joints back into the outer housing. Take out what was 

 used to secure the coil on the inner housing and press both housing parts 

 together until the Kaydon ball bearing fits into its seat in the outer 

 housing (see the assembly drawing from page A-l and step 27). 



43 



