7. 



Bond a piece of thick aluminum foil 

 over the groove of the stator mount. 

 Use an appropriate bond. 



Press the angular contact ball bear- 

 ing (FAG no B.7000.E) into the inner 

 housing so that it can take a thrust 

 load in the direction of the inner 

 housing. Make sure not to transmit 

 pressure or impact through the roll- 

 ing elements of the bearing while 

 pressing it in. 



Put the flexpline into the inner housing 

 and thread the wires through the fitting 

 hole. 



9. Thread the wires through the covered 

 groove of the stator mount and put the 

 stator mount into the flexpline. 



10. Screw all three parts together, 

 attention to the fit. 



Pay 



When all six bolts are tightened down, 

 take one bolt out. Put Loctite 290 

 adhesive/sealant on the thread and 

 torque the bolt down. Proceed until 

 all bolts are locked and sealed. 



54 



