35. Put outer and inner housings to- 

 gether as shown, and solder the 

 wires from the coil on the inner 

 housing to the wires running to 

 the fitting (shoulder rotate) or 

 the wires sticking out of the 

 outer housing (shoulder pivot). 

 Secure and insulate the soldered 

 joints with heat-shrinkable tub- 

 ing. Make sure that the wires 

 are long enough to repeat this 

 procedure in case of necessary 

 replacement of motor parts. 

 Make sure that during the as- 

 sembly process the motor arm- 

 ature cannot come out of the 

 motor field (see 32). 



36. Bend the soldered joints back 

 into the outer housing. Take 

 out what was used to secure the 

 coil on the inner housing and 

 press both housing parts to- 

 gether until the Kaydon ball 

 bearing fits into its seat in 

 the outer housing (see the 

 assembly drawing from page B-l). 

 Make sure that during the as- 

 sembly the motor armature can- 

 not come out of the motor field. 



37. Mark the possible 



movement from the com- 

 pressed coil to the 

 stretched coil on inner 

 and outer housings. 



64 



