ASSEMBLY PROCEDURE 



Clean all metal surfaces 

 very thoroughly. Make sure 

 that all deposits from pre- 

 viously used liquids such 

 as cutting oils, masking 

 paints, galvanic solutions, 

 etc, are removed. 



2. Put Loctite Quick Set 404 

 adhesive on the outside 

 diameter of two 0-rings 

 (Parker no 2-104 V747-75). 

 Push the 0-rings into the 

 bore so that they just fit 

 inside. Cover the adhesive 

 bond with Loctite water- 

 proofing solution. 



Press the angular contact 

 ball bearing (FAG no B.7000.E; 

 into the inner housing so 

 that it can take a thrust 

 load in the direction of the 

 inner housing. Make sure 

 not to transmit pressure or 

 impact through the rolling 

 elements of the bearing 

 while pressing it in. 



31 



