This JCL for running RCPWAVE on the CYBER 205 must first pass through the 

 CYBER 865 front-end computer. The first section of lines in the JCL deals 

 with preparation of the program RCPWAVE on the front end and the subsequent 

 relay to the CYBER 205. All JCL is described in detail in Appendix E. 



Submitting the CYBER 205 Batch Job 



73. The procedure for submitting a batch job for processing on the 

 CYBER 205 is identical to that used for the CYBER 865. The following command 

 sends the JCL shown in Figure 7 to the front-end CYBER 865 and ultimately to 

 the CYBER 205: 



SUBMIT, RCP205 J, T 



Computer response to the SUBMIT command informs the user of the computer gen- 

 erated job name (AKQBRUD in this case). 



74. Status of the job sent to the front-end CYBER 865 is checked in the 

 same manner as was presented before, using the ENQUIRE command: 



ENQUIRE,JN=RUD 



When the job AKQBRUD is in the PRINT-TERMINAL QUEUE, as shown below, 



AKQBRUD IN PRINT - TERMINAL QUEUE 



then a job should have been routed to the CYBER 205. Whether or not this oc- 

 curred can be determined by checking the diary of events by typing 



0LD,RCPDAYF 



LIST 



or by typing 



QGET,RUD 



XEDIT, AKQBRUD 



and then using the editor to locate the diary of events in this file. The 

 dayfile should contain the following lines, including the seven-letter jobname 

 given to the file SENDJ0B by the computer: 



1 3 • 40 . 08 . SUBMIT , SENDJ0B , T . 



13.40.08. SUBMIT COMPLETE. JOBNAME IS AKQBRUZ . 



43 



