References 



1. Candle, R.D., "Scrap Tire Shore Protection Structures," Engineering 

 Research Dept., Goodyear Tire and Rubber Co., Akron, OH, 1976. 



2. Giles, M.L., Sorenson, R.M., "Prototype Scale Mooring Load and 

 Transmission Tests for a Floating Tire Breakwater," Technical Paper No. 

 78-3, U.S. Army Corps of Engineers, Coastal Engineering Research Center, 

 Fort Belvoir, VA, April, 1978. 



3. Harms, V.W,, "Data and Procedures for the Design of Floating Tire 

 Breakwaters," Water Resources and Environmental Engineering Research Report 

 79-1, Dept. of Civil Engineering, State University of New York, Buffalo, 

 NY, 1979. 



4. Harms, V.W., Westerink, J.J., "Wave Transmission and Mooring-Force 

 Characteristics of Pipe-Tire Floating Breakwaters", Report No. LBL-11778, 

 Lawrence Berkeley Laboratory, University of California, Berkeley, CA, 

 October, 1980. 



5. Pierce, R.E., Lewis, A.F., "Technical Feasibility Study on Floating Tire 

 Breakwaters - Engineering Measurements," Final Report to Pennsylvania 

 Science and Engineering Foundation, Pennsylvania Dept. of Commerce, Report 

 prepared on behalf of Lake Erie Institute for Marine Science, Erie, PA, 

 December, 1977. 



6. Pierce, R.E., "Fabrication, Installation and Field Test Procedures For a 

 Pipe-Tire Floating Breakwater," Oceans '83 Conference Record, Marine 

 Technology Society and I.E.E.E., San Francisco, CA, September, 1983. 



60 



