A. E. Verrill — North American Cephalopods. 
203 
The second division, 35'6 m in length, succeeds the small suckers. 
Here the arm is flattened on the face, well-rounded on the hack, and 
provided with a sharp dorsal carina, increasing in width toward the tip. 
It hears two alternating rows of about twelve very large serrated suck- 
ers, and an outer row of smaller ones, on each side, alternating with the 
large ones. The upper edge is bordered by a rather broad, regularly 
scalloped, marginal membrane, the scallops corresponding to the 
large suckers, while prominent transverse ridges, midway between the 
large suckers, join the membrane and form its lobes. On the lower 
edge there is a narrower and thinner membrane, which runs all the 
way to the tip of the aim. In one (the lower) of the rows of large 
suckers there are eleven, and in the other ten. above 20 mm in diameter. 
The former row has one additional sucker at its proximal end 15 mm 
in diameter, and three others at its distal end, respectively 16, 12, and 
8 mm in diameter. The other row, of ten sucker's, is continued by a 
proximal sucker 1 u in diameter, and by two distal ones, respect- 
ively 15 and 13 mm in diameter. The number of ‘ large ’ suckers iu 
each row may. therefore, be counted as 12, 13, or 14, according to the 
fancy of the describer, there being no well-defined distinction between 
the larger and smaller ones in either row. The largest suckers, along 
the middle of the rows, are from 24 mm to 30 mm in diameter (Plate 
XVI, fig. 3, </)• They are attached by slender but strong pedicels, 
about 10 u long and 6 to 7 ni!n iu diameter. The outer or back side 
of these suckers is 16 to 13 mm high; the front side 10 to ll mm , so 
that the rim is about 24 to 28 mtu above the surface of the arm. The 
horny rings are 7 to 8 u ‘ m high and have the aperture 20 to 23 nim iu 
diameter. Each one is situated in the center of a pentagonal de- 
pressed area, about 2 v across, bouuded by ridges, which alternate 
regularly, and interlock on the two sides, so as to form a zigzag line 
along the middle of the arm These large suckers are broadly and 
obliquely campanulate, but much less oblique than those of the short 
arm'*, the marginal ling is sti'ong, and sharply serrate all around; 
the denticles are acute-triangular and nearly equal. The rings are 
somewhat calcified and rather rigid when dried ; a well-marked broad 
groove runs around the entire circumference, below the bases of the 
denticles. 
The small marginal suckers (fig. 3, b) are similar in structure, but 
much more oblique, and mostly 9 to 1 l mm in diameter ; they are 
attached by much longer and more slender pedicels, and their mar- 
ginal teeth are relatively longer, sharper and more incurved, espe- 
cially on the outer margin. The peripheral groove is broad and deep. 
