<<5^ JAOaGS T^9i>I 297 



James Sanitary Horse Box Stall 



SPECIFICATIONS 



CORNER AND INTERMEDIATE POSTS: ISg-m. O. D. pipe extending into 



floor. 

 GATE POSTS: 1^8-in- O. D. double strength pipe reinforced at the top of partition 



wall by a 1 5 g-m. O. D. pipe embedded in cement. 

 PANEL HORIZONTALS: i '->, 8-in. O. D. pipe. Top and bottom horizontals bolted 



together with '' ^^•-m. cut thread bolts, spaced not more than 4 spindles between bolts. 

 PANEL UPRIGHTS: P],;-m. O, D. pipe spaced approximately 5 '4 inches on 



centers. 

 FITTINGS: Best annealed malleable /n;-in. cut thread bolts used with fittings. 

 ORNAMENTS: Best malleable; dust-proof type. 

 GATE: Frame and center horizontals of 1 ^/g-in. O. D. pipe with 1 ' t(;-in. O. D. pipe 



upright spaced approximately lYi inches on lower half of gate. All fittings of 



best malleable. Equipped with safety lock and supported by 3 offset hinges of the 



best malleable. 

 GATE LOCK: Double latch, connected by %-in. square steel rod. Gate locks when 



slammed shut, can be opened only by hand, it being necessary to raise the lever 



and turn. 

 FINISH: The steel is first mechanically cleaned, removing scale, grease and foreign 



matter, then followed with chemical bath, thoroughly preparing the material for 



painting; it is then finished with the best grey protective enamel, baked for two 



hours at a high temperature. (See page 125.) 

 HEIGHT: With 6-in. curb under gate stall is 6 feet 5 inches from the floor. 



Shipped assembled in panels. 



Complete Panel Fronts and Guards for Horse Stall 



SPECIFICATIONS 



POSTS: 1 5 8-in. O. D. pipe extending below floor line. 



PANEL HORIZONTALS; l''8-in. O. D. pipe. Top and bottom horizontals of 



both upper and lower panels are bolted together separately with "ir.-in. cut thread 



bolts. 

 PANEL UPRIGHTS: lini-in. O. D. pipe spaced approximately 5 inches on centers. 

 FITTINGS; Best malleable 'ir.-in. cut thread bolts used with fittings for attaching 



panels to posts. 

 FINISH: The steel is first mechanically cleaned removing scale, grease and foreign 



matter, then followed with a chemical bath, thoroughly preparing the material for 



painting; it is then finished with the best grey protective enamel, baked for two 



hours at a high temperature. 

 HEIGHT: 6 feet 9 inches from the floor. 



Shipped assembled in panels. 



Feed Manger 



Manger is of 1 8-gauge galvanized sheet steel; ends are locked seamed with reinforcing 

 plates on corners. Furnished with an iron clean-out and tie ring. 



