Wired J'rames, 195 



fourths (i/i) of an inch from the side of the hive. This 

 makes it easy to pnt in the frames without crushing the 

 bees. It might be supposed that the bees would build 

 combs between the lower end of the frame and the hive, 

 but I have never yet seen a case of the kind, and I have 

 used such frames now quite extensively for several years. 

 These frames reverse very easily, and I do not know a 

 single person who has thoroughly tried them, who does not 

 value them highly.. Here again let me suggest that in 

 making changes , a few be tried Jirst, and not all till we 

 know we wish them. 



As the use of comb foundation secures straight combs, 

 with no drone cells, it is very desirable. When this is 

 fastened bv. merely pressing or sticking it to the top-bar, 

 it is apt to sag and warp, hence it is becoming quite the 

 custom to wire the frames. (Fig. 70.) This insures per- 

 fect safety if we wish to ship our bees, and secures against 

 sagging or bulging of the foundation. If the foundation 

 is put on with the Given press as the foundation is made, 

 No. 36 wire is used ; if pressed on by hand No. 30 wire, 

 is better. The timber for frame should be thoroughly 

 seasoned, and of the best pine or whitewood. Care should 

 be taken that the frame be made so as to hang vertically, 

 when suspended on the rabbets of the hive. To secure 

 this very iinfortant point — true frames that will always 

 hang true — they should alwa3's be made around a guide. 



A BLOCK FOR MAKING FRAMES. 



This may be made as follows : Take a rectangular board 

 /Fig. 71) eleven and one-eighth by thirteen and a quarter 

 inches. . On both ends of one face of this, nail hard- wood 

 pieces (Fig. 71, e, e) one inch square and ten and three- 

 fourths inches long, so that one end (Fig. ']i,g,g) shall 

 lack three-eighths inch of reaching the edge of the board. 

 On the other face of the board, nail a strip (Fig. 71, c) 

 four inches wide and eleven and three-eighths inches-long, 

 at right angles to it, and in such position that the ends shall 

 just reach to the edges of the board. Midway between the 

 one inch square pieces, screw on another hard-wood strip 

 (Fig. T^i d) one inch square and four inches long, parallel 



