<^^ JAl?aGS OJaV 303 



James Concrete Horse Box Stall 



I See Page 302 



SPECIFICATIONS 



CORNER AND INTRl^MEDIATE POSTS: 15,y-,n. O. D. pipe extending into 

 floor. 



GATE POSTS: I ^8-in. O. D. double strength pipe reinforced at the top of partition 

 wall by a 1 ' g-in. O. D. pipe embedded in cement. 



PANELS: these consist of the square end horse stall guards (page 299); the 

 uprights being of I/2 in. round steel spaced 3 inches apart, fitted into 1 A"'"- O. D. 

 top horizontal and securely riveted through a 1 j/S-in. by %-in. channel below. 

 Height ot panel 26 in. Standard length 6 leet but made any length special. 



FITTINGS; Best annealed malleable ~i(;-in. cut thread bolts used with fittings. 



ORNAMENTS: Best malleable; dust-proof type. 



GATE: Frame and center horizontals of I -J (5-in. O. D. pipe with ['/"ig-in. O. D. pipe 

 upright spaced approximately lYi inches on lower half of gate. All fittings of 

 best malleable. Equipped with safety lock and supported by 3 offset hinges of the 

 best malleable. 



GATE LOCK: Double latch, connected by %-in. square steel rod. Gate locks when 

 slammed shut, can be opened only by hand, it being necessary to raise the lever 

 and turn. 



FINISH: The steel is first mechanically cleaned, removing scale, grease and foreign 

 matter, then followed with chemical bath, thoroughly preparing the material for 

 painting; it is then finished with the best grey protective enamel, baked for two 

 hours at a high temperature. (See page 129.) 



HEIGHT: With 6-in. curb under gate stall is 6 feet 5 inches from the floor. 

 Shipped assembled in panels. 



James Wood Horse Box Stall 



SPECIFICATIONS 



For a horse box stall of planks instead of concrete, specifications are same as above 

 excepting that all posts have fittings and channels attached necessary to take planks 

 I y^ in. thick. 



