( 66 ) 



drive well together. Our next job (6) deals with the hack of house. 

 For this use two pieces 8 ft. long ; mark off 2 in. each end, 2 in. in 

 centre. We then need three rails same length as front ; tenon and 

 drive these together. Finally we come to the ends of our house. 

 For these cut three pieces 5 ft; 6J in. for end opposite door. On 

 the inside of these screw an iron angle-bracket. 



Put these latter so that when the back and front are in place 

 the respective squares can be screwed to the rails of back and front 

 end, one of which has the door in it. (7.) Cut one'piece 5-ft.'6|-in. 



Kg. 2.— Blevatioit. 



board, find centre, and mark off width of door each side ; the door is 

 four boards wide, i.e., two boards in width on each side of centre ; 

 mortise for uprights ; tenon uprights to fit. Bore a small hole in 

 bottom of uprights (to take a ^-in. iron pin), and bore hole in floor 

 to correspond ; then screw two more of the angle-brackets to end of 

 this rail. (8.) Place floor where it is to stand on four bricks. 

 Fix up the front and back on it, and stay them in their places. 

 Screw the end rails up in position. The framework will now be 

 in its proper place. Get some pieces of 2 in. by 2 in. scantling 

 for rafters; notch them a little to bear on front and back (do 

 not nail them down ) You will now need a few cabin-hooks and 

 eyes, and these must be fastened on so as to be easily hooked or 



