Equipment ANt) loft NEcBssiTiEs 229 



three groups of cleats across the table at each of the three 11 

 inch marks having the center cleat of each group centered di- 

 rectly over the mark. Nail the twro outside cleats oi each group 

 to the table and remove the center loose cleats which were used 

 only for quick measure and your rack is complete. The 11 

 inch marks must extend straight across the table to and up the 

 back board and the cleats must be the same distance apart at 

 the back of the table as at the front. See drawing. 



FRAME ON WHICH TO MAKE UPRIGHT NEST PARTITIONS 

 The above frame can be made on the top of a bench or table but it 

 Is preferable to make it out of separate lumber. 



Place five cleats in all five of the inch wide spaces on the 

 pattern rack or table, cover them with enough boards i/^ inch 

 thick or one inch thick and 45 inches long to make a width of 

 18 inches. Then directly over the two end and the three center 

 loose cleats, lay five other cleats 18 inches long and nail straight 

 through these top cleats down through the partition boards into 

 the loose cleats underneath. Use nails long enough to go almost 

 through the lower cleats. When this is done, the nest partition 

 can be lifted out of the pattern rack completed with cleats on 

 both sides and will be so constructed that it can be used either 

 end up. 



