142 BUTTER-MAKING. 



inlet can be closed to such an extent as to cause nearly all the 

 discharge to take place through the skim-milk tube. 



As a rule when the machine has been set so as to allow the 

 milk to flow in at a certain rate, it will continue to admit prac- 

 tically the same amount of milk all through the skimming 

 period. Among the conditions which may alter the rate of 

 inflow to some extent, are the amount of heat and the change 

 of pressure, due to different amoimts of milk in the receiving-- 

 vat. Temperature will slightly affect the rate of inflow. The 

 higher the temperature, all other conditions being the same, 

 the more milk will pass through the inlet. 



3. Speed. — All modern machines have a device by which their 

 speed can be determined. Most speed indicators consist of a 

 little wheel, which, when pushed up against the spindle of the 

 separator while running, turns around and permits the calcu- 

 lation of the speed of the separator. If the wheel on the speed- 

 indicator turns 10 revolutions during ten seconds, the machine 

 would turn 1000 times during the same time. During one 

 minute the separator will run six times as many revolutions, 

 or 6000, as ten seconds is one-sixth of a minute. Most speed- 

 indicators are so adjusted as to turn one revolution for every 

 100 revolutions of the machine. The higher the speed, the 

 more thorough is the separation. Nearly all machines are 

 balanced to do the best work at a certain definite speed, varying 

 with different machines, and indicated in the directions for 

 operating. It is essential that the machine should be brought 

 up to speed gradually, and no milk be allowed to flow through 

 it \mtil after it has acquired its full speed. 



During the run, all machines are likely to vary more or less 

 in speed, owing to different causes. Pulleys are hkely to slip 

 on the shaft, and belts are likely to become loose, and thus 

 cause variations in the speed. The steam pressure is hkely 

 to get low, and cause ah of the machinery in the creamery to 

 run more slowly. This cause, however, is not a very common 

 one where belt separators are used. If the engine has an auto- 



