ACCESSORIES AND APPLIANCES 
how out of the way the regulator is. 
Many who have other machines are buy- 
ing them to replace the out-of-date ones 
that are on their machines. 
To put on the regulator: Draw a line 
back of heater parallel with bottom of 
machine 73%” above it; draw another per- 
pendicular line 414” back of heater; at 
the point where the lines cross put the 
center of your bit and bore straight 
through, a 114” hole. Slip the regulator 
tube through from inside until it is flush 
with outside, drive a small tack in hole 
near outer end of tube; now put on ful- 
crum bracket in center of back side of 
heater, flush with upper end, and fasten 
with four small screws. Put damper 
lever on fulcrum bracket, slip connect- 
ing rod through thermostat lever, turn 
on adjusting nut and hang on damper 
and there you are. 
Use flooring for this 
7” thick. Lay on across 
the short way; they should be flush with 
outside of box all around. 
Now see that your heater pipes are in 
proper place and drive a small nail down 
through top into upper heater pipe near 
109 
Top of Box 
