36 Testing milk and its Products. 



gravimetric analyses have shown that the readings ob- 

 tained in this manner give correct results. While the 

 lower line of the fat column is nearly straight, the upper 

 one is curved, and errors in the reading are therefore 

 easily made, unless the preceding rule is observed. 



Results with 8% boltles (44a) agree well with those 

 obtained with the 10% bottles, when care is taken to 

 read the fat column to the extreme top of the menis- 

 cus. This appears especially thin in the former bottles 

 and cannot be seen quite as readily as in the 10% 

 bottles. 



The fat obtained should form a dear yellowish liquid 

 distinctly separated from the acid solution beneath it. 

 There should be no black or white sediment in or below 

 the column of fat, and no bubbles or foam on its sur- 

 face. The bottles must be kept warm until the read- 

 ings are made, so that the column of fat will have a 

 sharply defined upper and lower meniscus. When the 

 testing is done in a cold room, it is a good plan to place 

 the bottles in a pail with water of 140° P. be- 

 fore readings are made. The readings should always 

 be made when the fat has a temperature of about 140° 

 P. ; too low results will be obtained if the fat is allowed 

 to cool below 120° P., and too high if readings are 

 taken above 150°. The fat separated in the Babcock 

 test solidifies at about 100° P. If the fat is partly sol- 

 idified, it is impossible to make an accurate reading.* 



' The effect of differences in the temperature of the tat on the read- 

 ings obtained will be seen from the following : If 110 and 150° P. be 

 taken as the extreme temperatures at which readings can be made, 

 this difference of 40° F. (22.3° C.) would maKe a difference in the vol- 

 ume of the fat column obtained in the case of 10 per cent, milk of 

 .00084x2x22.a=.028544 cc., or ,14 per ecut., .00064 being the expansion 

 coefficient of pure butter fnt per degree Centigrade between 50 and 100° 



