Uz MANUAL OF APICULTURE. 
bees from their combs, cut out the latter, and fit them into frames. If 
the combs thus fitted in are held temporarily in place in the frames, 
the bees, under whose care they should be placed at once, will fasten 
them securely in a few hours or days at most. To drive the bees from 
the box hive proceed as follows: Toward the middle of a pleasant day 
blow smoke into the hive to be transferred, and after the bees have 
been given a few minutes in which to lap up their fill of honey, invert 
the hive and place over the open end an empty box, or the frame hive 
itself, making whichever is used fit closely on the hive (fig. 53). By 
rapping continuously for some minutes on the hive the bees will be 
impelled to leave it and cluster in the upper box. A loud humming 
will denote that they are moving. The hive thus vacated may then be 
taken into a closed room and sne side pried off to facilitate the removal 
of the combs. The box containing the bees is to be placed meanwhile 
on the spot originally occupied by the box hive, the bees being allowed 
to go in and out without restraint, only two precautions being neces- 
sary, namely, to shade the box well and provide for ventilation by 
propping it up from the bottom, leaving also, if possible, an opening at 
the top. When the combs have been fitted into frames, the hive con- 
taining them is placed on the original stand and the bees shaken from 
the box in front of it. 
In filling the frames with combs cut from a box hive, the largest and 
straightest sheets having the most sealed worker brood in them should 
be selected first and so cut that the frame will slip over them snugly, 
taking pains, as far as possible, to have the comb placed in the frame 
in the same position in which it was built, since most of the cells, instead 
of being horizontal, are inclined upward, the inclination of the deeper 
store cells being greatest. The comb, if not heavy, can be held in place 
temporarily by slender wire nails pushed through holes punched in the 
side and top bars. Before the introduction of wire nails the writer used 
long thorns pulled from thorn-apple trees, which served the purpose 
very well. In the case of combs heavy with honey or brood or pieced 
more or less it will be safer to use, in addition to a few wire nails, a pair 
or two of transferring sticks. These are simply slender strips of wood 
slightly longer than the depth of the frame and notched at each end. 
By placing such a stick on either side of the comb and winding annealed 
wire around the top and bottom ends so as to draw the sticks firmly 
against the surface of the combs the latter will be held securely in the 
frames. The midrib between the rows of cells should be pressed neither 
to one side nor the other; thus, if cells on one side are deeper than those 
on the other, they should be shaved down, unless the honey will be cut 
into too much, in which case the comb may be allowed to project on one 
side until it has been fastened in the frame and the hive has been gen- 
erally put in order by the bees, the point being not to force them to try 
to manage too much running honey at one time, lest robbing be induced. 
In many instances the comb when pressed into the frame will seem to 
