8 



The cut shows the general way of setting up Nos. 2, 5 and 8 Mills, for Dry substances, with the Counter- 

 shaft set on the floor. 



Counter-shafts should bo placed from 6 to 10 ft. from the Mill. 



Belt to run with a quarter turn, as shown, and have an upward pull as it leaves the Mill as shown by 

 arrows on cut. 



The lower side of driving pulley on counter-shaft must be on a horizontal line with the centre of the 

 pulley on Mill. 



Mill must run to the right as shown by the arrows. 



Tight and loose pulleys on the No. 2 counter-shaft, 10 inohes diameter, 6 inch face each; average speed 

 of counter-shaft required, 275. Use a 4 inch or 6 inch belt. 



Tight and loose pulleys on the No. 5 counter-shaft, 14 inches diameter, 7 inch face each ; average speed 

 of counter-shaft required, 350. Use a 6 or 7 inch belt. 



Price of Counter-shaft, complete, for No 2 Mill ... $42 00 



" Nos. 5 and 8 Mill . . 60 00 



Price of Pulley for main shaft will depend upon the size required. 



In ordering Pulleys for main shaft diameter and speed of shaft should be given, also if regular balanced 

 or split pulley is required. 



Weight of No. 2 Counter-shaft, complete, about ... 250 lbs. 



" " " " boxed, about ... 425 lbs. 



" No. 5 " " about ... 400 lbs. 



" ' " " " boxed, about ... 650 lbs. 



View showing manner of setting up Nos. 2 and 5 Mills, for dry substances, witii Bevel Gearing. 



Bevel Gear, 1£ to 1. Floor space, 17 in. x 48 in. 



By the use of Bevel Gearing, as shown above, the Mill can be set up to occupy less space than in the 

 old way, with a counter-shaft on the floor, and being bolted on a bed-plate, are more portable and can be 

 placed anywhere, where grinding is required to be done. On the No. 2 Mill, one gear being iron and the 

 other wood, no noise is made by their use. The Nos. 5 and 8 Mills cin be run on the fame principle as 

 shown in above cut, but being heavier and larger Mills both gears are of iron. 



Extra price for Bevel Gearing, bo-^-plate, tight and loose pulley and shaft 

 for No. 2 Mill, 



do. do. do. without bed-plate, 



do. No. 5 Mill, do. with bed-plate, 



do. do. do. without bed-plate, 



Prices for Bevel Gearing for Nos. 5 and 8 Mills given on application. 



Weight of No. 2 Original Mill with Bovel Gear, etc., complete, about ... S'A5 lbs. 



$!50 00 

 138 00 

 210 00 

 192 00 



" " " boxed, about 1200 lbs. 



No. 5 « " " " " about ... 1 750 lbs. 



" « " " * " boxed, about 2200 lbs. 



