BRICK ROADS. 33 
grout is removed from the box, the mixture must be constantly well stirred 
with mortar hoes. The grout shall be removed from the box with scoop shovels 
and applied to the brick in front of men supplied with push brooms, who shall 
rapidly sweep it lengthwise of the brick into the joints until the joints are 
practically filled. After the first application has been made and the grout 
has settled into the joints, and before Initial set has taken place, the unfilled 
portion of the joints shall be filled with the thicker grout, and, if necessary, 
refilled until the joints remain full to the top. After this has been done the 
pavement shall be finished to a smooth surface, free from any surplus grout, 
with a squeegee, which shall be worked over the brick at an angle of about 
forty -five (45) degrees with the curb. The pavement shall have been thoroughly 
sprinkled before the first application of grout is made, and shall be kept moist 
by means of gentle sprinkling until the grout is spread. The top surface, sides, 
and ends of the brick shall be thoroughly clean at the time the work of filling 
the joints is done. 
Immediately after the grout has taken its initial set the pavement shall be 
covered with a one (1) inch layer of sand or earth. This layer, immediately 
after it is placed on the pavement, shall be thoroughly wet by sprinkling and 
shall be kept wet by sprinkling for at least the five ( 5 ) following days. It shall 
remain on the pavement for at least ten (10) days and shall be removed before 
traffic is permitted upon the pavement. During this period of ten (10) days or 
longer, as the engineer may require on account of weather conditions, no traffic 
shall be allowed upon and no materials shall be placed upon the pavement. 
Expansion cushion. 1 — An expansion cushion four (4) inches in depth and of 
the thickness indicated on the plans shall be constructed along each curb as 
follows : Suitable provision for the cushion shall be made at the time the brick 
are laid by setting boards of the proper width and thickness on edge in proper 
position along the curb. After the brick have been laid, rolled, and grouted, 
and the grout has well set, the boards shall be carefully removed, so as not to 
damage the curb or the brick pavement, and the spaces which they occupied 
shall be filled with blown-oil asphalt heated to a temperature of not less than 
three hundred (300) degrees Fahrenheit and not more than four hundred (400) 
degrees Fahrenheit. 
ALTERNATE SPECIFICATIONS. 
SEPAEATE CONCRETE CURBS. 
Where the plans call for concrete curbs separate from the foundation they 
shall be constructed before the subgrade is finally completed and shall have 
the cross section shown on the plans. Such curbs shall be constructed in sec- 
tions not less than six (6) feet and not more than twelve (12) feet in length 
and shall be true to grade and alignment. 
The specification already given for concrete curbs constructed in combination 
with the foundation shall also apply to curbs constructed separate from the 
foundation as regards proportioning, mixing, and placing the concrete, con- 
structing the forms, and all other features of construction which are not covered 
on the plans or in this specification. 
STONE CURBS. 
Where stone curbs are required, they shall be hauled and set before the 
subgrade is finally completed. The curbs shall be set true to line and grade 
1 Instead of making a poured joint, as above described, the cushion may be constructed 
of some of the specially prepared expansion-joint materials, subject to the approval of the 
engineer as to the material and method of construction. 
