382 
EXPLANATION OF PLATES. 
tlie bees to pass up into the surplus honey-receplacles. On this 
board, receptacles of glass or wood, of any size or shape, may bo 
set (see Glass hive opposite to the Frontispiece), instead of the 
upper box. Fig. 22 is a vertical longitudinal section, and Fig. 23 
a vertical cross-section. This hivo has glass on four sides, for 
purposes of general observation. A cornice under the projecting 
roof of the cover would improve its appearance. 
(u) Main bottom of hive, tongued and grooved, 3l"x20|"x 3". 
(b) Outer * bottom of hive, 27 J" x 183" x £". (c) Rabbeted strips 
for outer bollom, two pieces, 293"xl3"x3", and two pieces, 
173" x I i" X §". (d) Front and rear of lower outer case of hivo, 
one rabbet, in upper outer corner of each, -fe" x fa" ■ front, 1 1 x 
20 J" x 3" ; cut. out of the centre of the lower edge, 143" x 3"; 
rear, 43" x 20jj" x (c) Sides of lower outer part, with rabbets 
the same as front and rear (for form of this, see Fig. 20), two 
pieces, 313" long x3" thick, 43" wide at one end, and 123" wide 
at 43" from the other end, where a notch is cut out. deep 
x 4" long. (/) Roof of alighting-board, 23J"x4J"x3"; 3" 
thick in rear, and 3" thick in front, (g) Board under which bees 
pass into the hive, 143"x4"xi". ( h ) Front posts of lower hive, 
two pieces, 9J" long x4"x3". (i) Rear posts of lower hive, 
two pieces, 10" long x 1 3 " x 3". with tenon, 3"x3"x3", on one 
end. (_;) Front and rear strips of lower hive, on which the 
frames hang, two pieces, 153" x 1 3 " x 3", with rabbet, 3"xj", 
and notch, f"x3", cut at each end from upper side, (k) Side 
strips from post to post, in lower hive, 21 J"x3"x3", with notch, 
3" deep x 1 3", cut in the under side of each end. (1) Spare 
honey-board, 173" x 21 3" x 3", nine holes bored 1|" diameter 
x deep, and then bored through with a 13 " bit; these holes 
when not in use are covered with pieces of tin, cut out with a 
punch ; they may be bored plain, and covered with pieces of glass 
or wood, (m) Front and rear of lower part of cover, 63"x20|" 
x 3", rabbets (Fig. 22) yV’ x A”i 011 boll* upper and lower edges 
(«) Sides of lower part of cover, two pieces, 273" from front to 
rear x 63" x 3", with rabbets 1 ’ J " x for shape of these pieces. 
•This outer bottom map bo dispensed with, and clomps, 27?<x2x% Inched, 
noflod lengthwise to the bottom of tlio hive, about 1 Inch under and from Its sided, 
for getting hold of the hivo to lift it, und to prevent dampness. 
