EXPLANATION OF PLATES. 
377 
edge, J"; into the opposite, orsliort edge, drive two nails near the 
ends of the partition, letting them project 4". These nails serve 
the purpose of feet to support the weight of the honey which is stored 
n the short frames resting by one end on this partition. The par- 
tition is further held, across the centre of the length of the hive, 
by two screws, one passing through each side of the hive into tho 
partition, at the projections left upon the upper. part of tho ends. 
This partition is used only when a double set of small frames are 
put in a surplus honey-box of the same size as the lower hive. 
Small Frames for Surplus Honey. 
Top, 9|"x lJ"x T V'. Bottom, 74"x4"xi". Ends, or ver- 
tical pieces, two pieces, 84" X i" x 4". Triangular comb-guide, 
(if used), 64" x J" x i" x 4". 
Hive No. 2, with Observing-glass at the back. 
See perspective drawings (Figs. 16 and 17, p. 44), and the ver- 
tical longitudinal section (Fig. 9, p. 28), and the vertical cross- 
section (Fig. 13, p. 36), in which sectional drawings, and this 
bill of stock, and the two others immediately succeeding it, parts 
that are similar are marked with similar letters. This hive, in 
one of the three forms given, is recommended as the best for gen- 
eral use. 
(a) Bottom-board, 244" x 15" x 4", tongued and grooved to- 
gether, with the grain of the wood running across the hive ; the 
board to bo rabbeted from one surface, at each edge, across the 
grain, -fa" x fa", to fit into grooves formed in the sides (c) ; six 
holes arc to be bored from the largest surface of this board, first 
with a 1 4" centre-bit. deep, and then through with a 1 4" bit.* 
The centres of those holes are to be in the intersections of lines 
gaged 38" from the centre of the width of tho board, and 44", 
104", and 164", from tho rear of it. (b) Front of hive. 144" x 
84" x 4"; nail this between sides (c), 4" below their upper edges, 
and 4" from their notched ends, (c) Sides of hive, twi pieces, 
* These holes, when not in use, eve closed most conveniently by small covers cut 
out of refuse tin with ft punch. Thoy should be made only In tho bottom-boards 
of those lilvcs Intended to bo usod one over another. 
