Top Cover 
Fluorescent 
Tubes 
Globe 
Knob 
Base 
To Install Or Replace Batteries 
NOTE: Use 6 D cell flashlight type batteries. For longest life use alkaline 
batteries. 
1 . Be sure lantern is off and top cover is secure and closed. Turn lantern 
upside down and turn base and lift off. (Fig. 1) 
2 . Press tab and open battery cover. 
3 . Insert batteries. They must be installed as shown In Figure 2. Close 
battery cover and snap shut. 
4 . Replace base and turn O to close. Check to see that base is com¬ 
pletely screwed on. 
11 MODEL 5344 700 
II (GREEN) 
II MODEL 5344-703 
II (RED) 
THE COLEMAN CO. INC. \\ 
WICHITA, KS 67201 U 
ir SIX D SIZE BATTERIES 
U S. PATENT NO. 4663697 II 
l\ REQUIRED 
\\ Cl 
Fig. 1 
Fig. 2 
To Change 
Fluorescent TPbes 
NOTE: This lantern uses 2 standard 6 inch 4 
watt fluorescent tubes (Coleman replacement 
part # 5344-1131). 
1 . Make sure lantern is off. Turn top cover 
O until index mark ▼ is at open position. 
(Fig. 3) 
2 . Lift off cover and remove tube(s). 
Replace with new 6 inch 4 watt tube. (Fig. 4) 
3 . Replace top cover and turn ^ until 
index mark is at closed position. 
F'9- 3 Fig. 4 
To Remove Globe 
1. Follow steps 1 and 2 to change fluo¬ 
rescent tubes. 
2 . Remove both fluorescent tubes. 
3. Loosen and remove nut in center of 
handle cover and lift off. (Fig. 5) 
4 » Remove globe. 
5. Re-assemble in reverse order. 
NOTE: MAKE SURE ALIGNMENT 
NOTCH AT THE SMALL END OF 
GLOBE IS ALIGNED WITH TAB 
Fig. 5 
Operation 
Your Coleman Fluorescent 
Twin Tube Lantern has a 
three (3) position switch. 
The center position is OFF, 
turning the knob O to I 
only the left tube will light. 
This position provides 
maximum battery life. 
Turning the knob O to 
II, both tubes are produc¬ 
ing maximum light. 
