245 
procnemial plates; the extensor-tendinal canal is more strictly medial in Onemiornis, 
and the fore part of the inner distal condyle is less produced and less compressed. 
The gastrocnemial tubercle (g) is wanting in Aptornis, as in Dinornis. 
Fibula. 
The fibula (Pl. LXIX. fig. 6), about 6 inches in length, shows the usual subcom- 
pressed, convex head, with an articular surface, about 14 lines long by 4 lines broad, 
slightly curved backward: the head is slightly hollowed on the inner side, moderately 
convex externally ; the shaft gradually contracts to the usual pointed termination about 
two-thirds down the tibia; it shows the broad, rough, articular surface for the tibia on 
the tibial border, and two rough tuberosities for tendinous insertions (uv, v) on the 
outer side of the bone. 
Metatarsus. 
The metatarsal (Pl. LXX. figs. 1-4), which equals in length that of Dinornis 
geranotdes (ib. figs. 5 & 6), has less than two-thirds its breadth, but almost equals it in 
fore-and-aft extent of the proximal end, owing to the greater development of the 
calcaneal ridge, which is perforated as in Aptornis. The inner condylar cavity (fig. 2, i) 
is much less extended from before backward; the anterior intercondylar prominence 
(fig. 1, r) is broader and more produced: the calcaneal process (fig. 1, c) extends down- 
ward, as a low ridge, to within an inch of the distal trochlea (fig. 3); the calcaneal 
canal is 10 lines in length, and 4 lines in long diameter. The surface, sloping to the 
outer condyle, is excavated by three well-marked longitudinal grooves, increasing in 
width as they approach the outer condyle (e); the ridge (c’) dividing the two outer 
grooves is the thickest. The antero-posterior canal, between the outer and middle 
metatarsal, opens behind at the end of the outermost groove; that between the middle 
aud inner metatarsal opens behind upon the inner side of the base of the calcaneal pro- 
cess; the transverse section of the middle of the shaft is subtrihedral, not transversely 
oval as in Dinornis ; the inner trochlea (i) is not produced lower than the outer one (iv) ; 
the middle trochlea (iii) is narrower in proportion to its length, and less produced for- 
ward ; in each trochlea, and especially the outer and inner ones, the longitudinal canal 
is deeper than in Dinornis ; the interspace between the outer and middle trochlez is the 
widest, not, as in Dinornis, narrowest. The posterior boundary of the middle trochlea 
is more prominent, projecting further back beyond the shaft than in Dinornis, As 
compared with Palapterya, the metatarse is longer in proportion to its breadth; the 
ealcaneal process in Aptornis is shorter, more prominent, and more widely excavated ; 
there are no tendinal grooves on its outer side; the posterior ridge is not continued 
from it, and is nearer the inner border of the shaft ; the inner trochlea is not produced 
so low as the outer one in Aptornis, and there is an antero-posterior canal above the 
interspace between the outer and middle trochlee. 
2c 
